Zebra Flush Thru
Effective cleaning solution for Zebra line marking spray system & nozzles
Zebra Flush Thru is a specially formulated biodegradable cleaning solution, designed for cleaning the Zebra line marking machine pump, lines, nozzles and filters at the end of a line marking job.
Flush Thru comes in 10 litres containers and it effectively breaks down paint in the lines, in the nozzles and in the filters.
It must be used at the end of every line marking job to prevent blockages and ensure years of reliable service from your Zebra line marking machine.
Container Size: 10L
Directions For Use: Always clean your Zebra line marker after use and ensure that the cleaning procedure is carried out where residues can do no harm. Connect the bottle of Flush Thru to the machine via the pump probe. Switch on the pump and allow Flush Thru to run through the sprayer for a few seconds. Leave the machine to stand for approximately 5 minutes. Finally flush the system through using a container of clean water for approximately 1 minute. Also pour some Flush Thru into the nozzle container, leaving the nozzles and filters to soak for a while. Then rinse with water.
Health & Safety: Avoid contact with eyes. Avoid contact with skin. After contact with skin, wash immediately with plenty of water. Wear protective gloves when handling the product. Seek medical attention if irritation persists. Keep out of reach of children. A health and safety data sheet can be supplied on request.
